FlickerMaster

The SPE-6 will create realistic flicker effects that range from the flickering light of a movie or TV screen, candle light or gas light, to roaring flames and more. You can choose between random flicker and strobe. The new Flickermaster features a built-in dimmer with filtering to minimize interference with sound and other electronic equipment on the set. The rugged case has the control panel and knobs recessed for protection when you are toting the unit from job to job. 

Flickermaster SPE-6 Specifications Housing is constructed of 14 gauge aluminum with a black painted powder coat finish and built in carry handle. All knobs and input connections are recessed for safety. There are four knob controllers with white position pointer lines for the following functions: SELECT-off/dimmer/flicker/strobe, speed-varies rate for flicker/strobe, LOW LEVEL-to trim bottom output of flicker/strobe, and DIMMER-to adjust output from 100% to 0% of voltage using a smooth square law dimmer curve. Solid state dimmer electronics are fully filtered to minimize lamp noise. Front panel has remote female jack receptacle to connect optional remote control which can be either a simple closure switch or a 0 to 10 volt DC signal. Two LED indicator displays for POWER and STATUS. Fuse is rear panel accessible. Power in/out pigtails are 8 inch long #12/SJO wire with machined aluminum strain relief housings. Unit rests on 1/2in. high by 1in. diameter molded rubber legs, as manufactured by GAMPRODUCTS Inc., Hollywood CA.